Cisco D9854-I User Manual

361
Warning
Message
Type
Message
Cause/Remedy
Description
ID
SDI VBI (OP47
SDP)
Clear
Service disabled
–
–
90050
SDI VBI (OP47
MDP)
Set
VBI (OP47MDP):
configured line
collides with VII,
service will be
dropped
Cause: User selection.
Remedy: Change offset
for VBI OP47-MDP
VANC service.
VBI OP47-MDP
VANC service is
configured on the line
overlapping with PAL
or NTSC VII line.
90060
SDI VBI (OP47
MDP)
Clear
Line collision
with VII cleared
–
–
90060
SDI VBI (OP47
MDP)
Clear
Service disabled
–
–
90060
ETH REDN:
Link Speed
(D9854-I only)
Set
Links speed
mismatch
detected
Cause: Manual
configuration or auto-
negotiated speed on the
two Data ports is
different.
Remedy: Ensure that the
link speed on paired
ETH ports is identical.
Link speed is different
for two Data ports.
This condition may
trigger an overflow on
the Data port with a
lower link speed.
91000
ETH REDN:
Link Speed
(D9854-I only)
Clear
Link speeds are
identical
–
–
91000
ETH REDN:
Link Speed
(D9854-I only)
Clear
Link speed is not
resolved
–
–
91000
ETH REDN:
Link Speed
(D9854-I only)
Clear
Links speed is
not monitored in
manual modes
–
–
91000
MPoIP Bitrate
Port #<n>
Set
Total configured
output is
marginal or too
high
Cause: Aggregated
MPoIP bandwidth on
Port <n> is too high.
Remedy: Re-configure
the stream's output rate
to be within 90% of the
link speed on ETH port
<n>.
The configured MPEG
over IP bandwidth is
close or higher than
ETH port <n> link
speed. This condition
can trigger the actual
MPoIP overflow.
92000
92100
MPoIP Bitrate
Port #<n>
Clear
Total configured
output is normal
–
–
92000
92100
MPoIP Bitrate
Port #<n>
Clear
Inactive port,
monitoring
stopped
–
–
92000
92100

Cisco D9854-I Specifications

General

Brand	Cisco
Model	D9854-I
Category	Receiver
Language	English