Cisco Firepower 1010 User Manual

After the device successfully registers and you refresh the page, you see the following:
Step 6 Click the Enable/Disable control for each optional license as desired.
• Enable—Registers the license with your Cisco Smart Software Manager account and enables the controlled
features. You can now configure and deploy policies controlled by the license.
• Disable—Unregisters the license with your Cisco Smart Software Manager account and disables the
controlled features. You cannot configure the features in new policies, nor can you deploy policies that
use the feature.
• If you enabled the RA VPN license, select the type of license you want to use: Plus, Apex, VPN Only,
or Plus and Apex.
After you enable features, if you do not have the licenses in your account, you will see the following
non-compliance message after you refresh the page:
Cisco Firepower 1010 Getting Started Guide
106
Threat Defense Deployment with the Device Manager
Configure Licensing

Cisco Firepower 1010 Specifications

General

VPN Throughput	500 Mbps
Concurrent Sessions	100, 000
Maximum Concurrent Sessions	200, 000
Ports	8 x 1 GE
Humidity	10% to 90% non-condensing
Form Factor	Desktop
Flash Memory	8 GB
Interfaces	8 x RJ-45
Power Supply	Internal
Dimensions (H x W x D)	4.44 x 21.59 x 17.27 cm
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-20 to 70°C
Memory	4 GB