Cisco Firepower 1010 User Manual

Enter new password: ********
Confirm new password: ********
Your password was updated successfully.
[...]
firepower#
Step 2 At the FXOS CLI, show the running version.
scope ssa
show app-instance
Example:
Firepower# scope ssa
Firepower /ssa # show app-instance
Application Name Slot ID Admin State Operational State Running Version Startup
Version Cluster Oper State
-------------------- ---------- --------------- -------------------- ---------------
--------------- ------------------
ftd 1 Enabled Online 7.2.0.65 7.2.0.65
Not Applicable
Step 3 If you want to install a new version, perform these steps.
a) If you need to set a static IP address for the Management interface, see (Optional) Change Management
Network Settings at the CLI, on page 97. By default, the Management interface uses DHCP.
You will need to download the new image from a server accessible from the Management interface.
b) Perform the reimage procedure in the FXOS troubleshooting guide.
(Optional) Change Management Network Settings at the CLI
If you cannot use the default management IP address, then you can connect to the console port and perform
initial setup at the CLI, including setting the Management IP address, gateway, and other basic networking
settings. You can only configure the Management interface settings; you cannot configure inside or outside
interfaces, which you can later configure in the GUI.
You cannot repeat the CLI setup script unless you clear the configuration; for example, by reimaging. However,
all of these settings can be changed later at the CLI using configure network commands. See Command
Reference for Secure Firewall Threat Defense.
Note
Cisco Firepower 1010 Getting Started Guide
97
Threat Defense Deployment with the Device Manager
(Optional) Change Management Network Settings at the CLI

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English