Cisco Firepower 1010 - Before You Start; End-to-End Procedure

• Complete the Threat Defense Initial Configuration, on page 15
• Log Into the Management Center, on page 23
• Obtain Licenses for the Management Center, on page 24
• Register the Threat Defense with the Management Center, on page 25
• Configure a Basic Security Policy, on page 28
• Access the Threat Defense and FXOS CLI, on page 43
• Power Off the Firewall, on page 44
• What's Next?, on page 45
Before You Start
Deploy and perform initial configuration of the management center. See the Cisco Firepower Management
Center 1600, 2600, and 4600 Hardware Installation Guide or Cisco Secure Firewall Management Center
Virtual Getting Started Guide.
End-to-End Procedure
See the following tasks to deploy the threat defense with management center on your chassis.
Cisco Firepower 1010 Getting Started Guide
6
Threat Defense Deployment with the Management Center
Before You Start