Cisco Firepower 1010 - Cable the Device (6.5 and Later)

Figure 2: Suggested Network Deployment
Cable the Device (6.5 and Later)
To cable the recommended scenario on the Firepower 1010, see the following illustration, which shows a
sample topology using Ethernet1/1 as the outside interface and the remaining interfaces as switch ports on
the inside network.
Other topologies can be used, and your deployment will vary depending on your requirements. For example,
you can convert the switch ports to firewall interfaces.
Note
Cisco Firepower 1010 Getting Started Guide
10
Threat Defense Deployment with the Management Center
Cable the Device (6.5 and Later)