Cisco Firepower 1010 User Manual

CHAPTER 4
Threat Defense Deployment with the Device
Manager
Is This Chapter for You?
To see all available operating systems and managers, see Which Operating System and Manager is Right for
You?, on page 1. This chapter applies to the threat defense with the device manager.
This chapter explains how to complete the initial set up and configuration of your threat defense using the
web-based device setup wizard.
The device manager lets you configure the basic features of the software that are most commonly used for
small networks. It is especially designed for networks that include a single device or just a few, where you
do not want to use a high-powered multiple-device manager to control a large network containing many device
manager devices.
About the Firewall
The hardware can run either threat defense software or ASA software. Switching between threat defense and
ASA requires you to reimage the device. You should also reimage if you need a different software version
than is currently installed. See Reimage the Cisco ASA or Firepower Threat Defense Device.
The firewall runs an underlying operating system called the Secure Firewall eXtensible Operating System
(FXOS). The firewall does not support the FXOS Secure Firewall chassis manager; only a limited CLI is
supported for troubleshooting purposes. See the Cisco FXOS Troubleshooting Guide for the Firepower
1000/2100 Series Running Firepower Threat Defense for more information.
Privacy Collection Statement—The firewall does not require or actively collect personally-identifiable
information. However, you can use personally-identifiable information in the configuration, for example for
usernames. In this case, an administrator might be able to see this information when working with the
configuration or when using SNMP.
• End-to-End Procedure, on page 90
• Review the Network Deployment and Default Configuration, on page 91
• Cable the Device, on page 94
• Power On the Firewall, on page 95
• (Optional) Check the Software and Install a New Version, on page 96
• (Optional) Change Management Network Settings at the CLI, on page 97
• Log Into the Device Manager, on page 99
• Complete the Initial Configuration, on page 100
• Configure Licensing, on page 102
Cisco Firepower 1010 Getting Started Guide
89

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English