Cisco Firepower 1010 User Manual

• Routed firewall mode only, using a routed interface.
• PPPoE is not supported. If your ISP requires PPPoE, you will have to put a router with PPPoE support
between the threat defense and the WAN modem.
• The interface must be in the global VRF only.
• SSH is not enabled by default for data interfaces, so you will have to enable SSH later using the
management center. Because the Management interface gateway will be changed to be the data interfaces,
you also cannot SSH to the Management interface from a remote network unless you add a static route
for the Management interface using the configure network static-routes command.
End-to-End Procedure: Low-Touch Provisioning
See the following tasks to deploy the threat defense with CDO using low-touch provisioning.
Figure 35: End-to-End Procedure: Low-Touch Provisioning
Obtain Licenses, on page 122.Cisco Commerce
Workspace
(CDO admin)
Cisco Firepower 1010 Getting Started Guide
119
Threat Defense Deployment with CDO
End-to-End Procedure: Low-Touch Provisioning

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English