Cisco Firepower 1010 User Manual

between the two devices. If you specify DONTRESOLVE in this command, then the threat defense
must have a reachable IP address or hostname.
• reg_key—Specifies a one-time registration key of your choice that you will also specify on the management
center when you register the threat defense. The registration key must not exceed 37 characters. Valid
characters include alphanumerical characters (A–Z, a–z, 0–9) and the hyphen (-).
• nat_id—Specifies a unique, one-time string of your choice that you will also specify on the management
center when you register the threat defense when one side does not specify a reachable IP address or
hostname. It is required if you set the management center to DONTRESOLVE. The NAT ID must not
exceed 37 characters. Valid characters include alphanumerical characters (A–Z, a–z, 0–9) and the hyphen
(-). This ID cannot be used for any other devices registering to the management center.
Example:
> configure manager add MC.example.com 123456
Manager successfully configured.
If the management center is behind a NAT device, enter a unique NAT ID along with the registration key,
and specify DONTRESOLVE instead of the hostname, for example:
Example:
> configure manager add DONTRESOLVE regk3y78 natid90
Manager successfully configured.
If the threat defense is behind a NAT device, enter a unique NAT ID along with the management center IP
address or hostname, for example:
Example:
> configure manager add 10.70.45.5 regk3y78 natid56
Manager successfully configured.
What to do next
Register your firewall to the management center.
Log Into the Management Center
Use the management center to configure and monitor the threat defense.
Before you begin
For information on supported browsers, refer to the release notes for the version you are using (see
https://www.cisco.com/go/firepower-notes).
Procedure
Step 1 Using a supported browser, enter the following URL.
Cisco Firepower 1010 Getting Started Guide
23
Threat Defense Deployment with the Management Center
Log Into the Management Center

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English