Cisco Firepower 1010 User Manual

!
dhcpd auto_config outside
dhcpd address 192.168.1.20-192.168.1.254 inside
dhcpd address 192.168.45.10-192.168.45.12 management
dhcpd enable inside
dhcpd enable management
!
http server enable
http 192.168.45.0 255.255.255.0 management
http 192.168.1.0 255.255.255.0 inside
!
dns domain-lookup outside
dns server-group DefaultDNS
name-server 208.67.222.222 outside
name-server 208.67.220.220 outside
!
Cable the Device
Manage the Firepower 1010 on either Management 1/1, or on Ethernet 1/2 through 1/8 (inside switch ports).
The default configuration also configures Ethernet 1/1 as outside.
Procedure
Step 1 Install and familiarize yourself with your hardware using the hardware installation guide.
Step 2 Connect your management computer to one of the following interfaces:
• Ethernet 1/2 through 1/8—Connect your management computer directly to one of the inside switch ports
(Ethernet 1/2 through 1/8). The inside interface has a default IP address (192.168.1.1) and also runs a
DHCP server to provide IP addresses to clients (including the management computer), so make sure
these settings do not conflict with any existing inside network settings (see Firepower 1010 Default
Configuration, on page 173).
Cisco Firepower 1010 Getting Started Guide
175
ASA Deployment with ASDM
Cable the Device

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English