Power On the Firewall
System power is controlled by the power cord; there is no power button.
The first time you boot up the threat defense, initialization can take approximately 15 to 30 minutes.
Note
Procedure
Step 1 Attach the power cord to the device, and connect it to an electrical outlet.
The power turns on automatically when you plug in the power cord.
Step 2 Check the Power LED on the back or top of the device; if it is solid green, the device is powered on.
Step 3 Check the Status LED on the back or top of the device; after it is solid green, the system has passed power-on
diagnostics.
Step 4 Observe the Status LED on the back or top of the device; when the device is booting correctly, the Status
LED flashes fast green.
If there is a problem, the Status LED flashes fast amber. If this happens, call your IT department.
Step 5 Observe the Status LED on the back or top of the device; when the device connects to the Cisco cloud, the
Status LED slowly flashes green.
If there is a problem, the Status LED flashes amber and green, and the device did not reach the Cisco Cloud.
If this happens, make sure that your network cable is connected to the Ethernet 1/1 interface and to your WAN
modem. If after adjusting the network cable, the device does not reach the Cisco cloud after about 10 more
minutes, call your IT department.
What to do next
• Communicate with your IT department to confirm your onboarding timeline and activities. You should
have a communication plan in place with the CDO administrator at your central headquarters.
• After you complete this task, your CDO administrator will be able to configure and manage the device
remotely. You're done.
Cisco Firepower 1010 Getting Started Guide
131
Threat Defense Deployment with CDO
Power On the Firewall
To Next Page
Loading...
Need help?
General
