determined that you are allowed to use strong encryption, you can manually add a strong encryption license
to your account.
Before you begin
• Have a master account on the Smart Software Manager.
If you do not yet have an account, click the link to set up a new account. The Smart Software Manager
lets you create a master account for your organization.
• Your Smart Software Manager account must qualify for the Strong Encryption (3DES/AES) license to
use some features (enabled using the export-compliance flag).
Procedure
Step 1 Make sure your Smart Licensing account contains the available licenses you need, including at a minimum
the Standard license.
When you bought your device from Cisco or a reseller, your licenses should have been linked to your Smart
Software Manager account. However, if you need to add licenses yourself, use the Find Products and
Solutions search field on the Cisco Commerce Workspace. Search for the following license PIDs:
Figure 54: License Search
• Standard license—L-FPR1000-ASA=. The Standard license is free, but you still need to add it to your
Smart Software Licensing account.
• Security Plus license—L-FPR1010-SEC-PL=. The Security Plus license enables failover.
• Strong Encryption (3DES/AES) license—L-FPR1K-ENC-K9=. Only required if your account is not
authorized for strong encryption.
• Anyconnect—See the Cisco AnyConnect Ordering Guide. You do not enable this license directly in the
ASA.
Step 2 In the Cisco Smart Software Manager, request and copy a registration token for the virtual account to which
you want to add this device.
a) Click Inventory.
b) On the General tab, click New Token.
Cisco Firepower 1010 Getting Started Guide
180
ASA Deployment with ASDM
Configure Licensing
To Next Page
Loading...
Need help?
General
