Cisco Firepower 1010 User Manual

Figure 55: View Token
Figure 56: Copy Token
Step 3 In ASDM, choose Configuration > Device Management > Licensing > Smart Licensing.
Step 4 Click Register.
Step 5 Enter the registration token in the ID Token field.
You can optionally check the Force registration check box to register the ASA that is already registered, but
that might be out of sync with the Smart Software Manager. For example, use Force registration if the ASA
was accidentally removed from the Smart Software Manager.
Step 6 Click Register.
The ASA registers with the Smart Software Manager using the pre-configured outside interface, and requests
authorization for the configured license entitlements. The Smart Software Manager also applies the Strong
Encryption (3DES/AES) license if your account allows. ASDM refreshes the page when the license status is
updated. You can also choose Monitoring > Properties > Smart License to check the license status,
particularly if the registration fails.
Step 7 Set the following parameters:
a) Check Enable Smart license configuration.
Cisco Firepower 1010 Getting Started Guide
182
ASA Deployment with ASDM
Configure Licensing

Cisco Firepower 1010 Specifications

General

VPN Throughput	500 Mbps
Concurrent Sessions	100, 000
Maximum Concurrent Sessions	200, 000
Ports	8 x 1 GE
Humidity	10% to 90% non-condensing
Form Factor	Desktop
Flash Memory	8 GB
Interfaces	8 x RJ-45
Power Supply	Internal
Dimensions (H x W x D)	4.44 x 21.59 x 17.27 cm
Operating Temperature	32°F to 104°F (0°C to 40°C)
Storage Temperature	-20 to 70°C
Memory	4 GB