Cisco Firepower 1010 User Manual

The following example configures a routed mode inside interface (VLAN1) with a static address and a routed
mode outside interface using DHCP (Ethernet1/1).
Procedure
Step 1 Choose Devices > Device Management, and click the Edit ( ) for the device.
Step 2 Click Interfaces.
Step 3 (Optional) Disable switch port mode for any of the switch ports (Ethernet1/2 through 1/8) by clicking the
slider in the SwitchPort column so it shows as disabled ( ).
Step 4 Enable the switch ports.
a) Click the Edit ( ) for the switch port.
b) Enable the interface by checking the Enabled check box.
c) (Optional) Change the VLAN ID; the default is 1. You will next add a VLAN interface to match this ID.
d) Click OK.
Step 5 Add the inside VLAN interface.
a) Click Add Interfaces > VLAN Interface.
Cisco Firepower 1010 Getting Started Guide
29
Threat Defense Deployment with the Management Center
Configure Interfaces (6.5 and Later)

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English