Cisco Firepower 1010 User Manual

policies only support security zones; you can use zones or interface groups in NAT policies, prefilter
policies, and QoS policies.
e) Click the IPv4 and/or IPv6 tab.
• IPv4—Choose Use Static IP from the drop-down list, and enter an IP address and subnet mask in
slash notation.
For example, enter 192.168.1.1/24
• IPv6—Check the Autoconfiguration check box for stateless autoconfiguration.
f) Click OK.
Step 4 Click the Edit ( ) for the interface that you want to use for outside.
The General tab appears.
If you pre-configured this interface for manager access, then the interface will already be named,
enabled, and addressed. You should not alter any of these basic settings because doing so will disrupt
the management center management connection. You can still configure the Security Zone on this
screen for through traffic policies.
Note
Cisco Firepower 1010 Getting Started Guide
34
Threat Defense Deployment with the Management Center
Configure Interfaces (6.4)

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English