Cisco Firepower 1010 User Manual

Branch Office Installation
After you receive the threat defense from central headquarters, you only need to cable and power on the
firewall so that it has internet access from the outside interface. The central administrator can then complete
the configuration.
Cable the Firewall
The management center and your management computer reside at a remote headquarters, and can reach the
threat defense over the internet. To cable the Firepower 1010, see the following steps.
Figure 18: Cabling a Remote Management Deployment
Procedure
Step 1 Install the chassis. See the hardware installation guide.
Step 2 Connect the outside interface (Ethernet 1/1) to your outside router.
Step 3 Cable your inside end points to the switch ports, Ethernet1/2 through 1/8.
Step 4 (Optional) Connect the management computer to the console port.
At the branch office, the console connection is not required for everyday use; however, it may be required
for troubleshooting purposes.
Cisco Firepower 1010 Getting Started Guide
63
Threat Defense Deployment with a Remote Management Center
Branch Office Installation

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English