Cisco Firepower 1010 User Manual

The following figure shows the default network deployment for the threat defense using the device manager
with the default configuration.
Figure 25: Suggested Network Deployment
For 6.7 and earlier, the inside IP address is 192.168.1.1.
For 6.5 and earlier, the Management 1/1 default IP address is 192.168.45.45.
Note
Default Configuration
The configuration for the firewall after initial setup includes the following:
• inside—IP address (7.0 and later) 192.168.95.1; (pre-7.0) 192.168.1.1.
• (6.5 and later) Hardware switch—Ethernet 1/2 through 1/8 belong to VLAN 1
• (6.4) Software switch (Integrated Routing and Bridging)—Ethernet 1/2 through 1/8 belong to bridge
group interface (BVI) 1
• outside—Ethernet 1/1, IP address from IPv4 DHCP and IPv6 autoconfiguration
Cisco Firepower 1010 Getting Started Guide
92
Threat Defense Deployment with the Device Manager
Default Configuration

Cisco Firepower 1010 Specifications

General

Brand	Cisco
Model	Firepower 1010
Category	Firewall
Language	English