Cisco IE-3000-8TC Hardware Installation Guide

CHAPTER
2-1
Cisco IE 3000 Switch Hardware Installation Guide
OL-13017-01
2
Switch Installation
This chapter describes how to install your switch, interpret the power-on self-test (POST), and connect
the switch to other devices.
Caution If your installation is in a hazardous environment, see Appendix B, “Installation In a Hazardous
Environment” for instructions.
Read these topics, and perform the procedures in this order:
• Preparing for Installation, page 2-1
• Adding Modules to the Switch, page 2-5
• Installing or Removing the Compact Flash Memory Card, page 2-10
• Verifying Switch Operation, page 2-11
• Installing the Switch, page 2-23
• Connecting Power and Alarm Circuits, page 2-32
• Connecting Destination Ports, page 2-36
• Connecting the Switch to the Power Converter, page 2-44
• Where to Go Next, page 2-53
Preparing for Installation
This section provides information about these topics:
• Warnings, page 2-2
• Installation Guidelines, page 2-3
• Verifying Package Contents, page 2-5

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes