Cisco IE-3000-8TC Hardware Installation Guide

B-1
Cisco IE 3000 Switch Hardware Installation Guide
OL-13017-01
APPENDIX
B
Installation In a Hazardous Environment
This chapter describes how to install your switch, interpret the power-on self-test (POST), and connect
the switch to other devices when in a hazardous environment.
Read these topics, and perform the procedures in this order:
• Preparing for Installation, page B-1
• Adding Modules to the Switch, page B-8
• Installing or Removing the Compact Flash Memory Card, page B-13
• Verifying Switch Operation, page B-14
• Installing the Switch, page B-26
• Connecting Power and Alarm Circuits, page B-36
• Connecting Destination Ports, page B-41
• Connecting the Switch to the Power Converter, page B-49
• Where to Go Next, page B-59
Preparing for Installation
This section provides information about these topics:
• Warnings, page B-2
• Installation Guidelines, page B-5
• Verifying Package Contents, page B-7

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes