Cisco IE-3000-8TC Hardware Installation Guide

B-8
Cisco IE 3000 Switch Hardware Installation Guide
OL-13017-01
Appendix B Installation In a Hazardous Environment
Adding Modules to the Switch
For multimode (MM) connections, you can connect a 100BASE-FX port to a port on a target device by
using an dual-LC connector.
Adding Modules to the Switch
The Cisco IE-3000-4TC or the Cisco IE-3000-8TC switch can operate as standalone devices with four
or eight Fast Ethernet ports, respectively. To increase the number of Fast Ethernet ports by 8 or 16, you
can connect the Cisco IEM-3000-8TM and the Cisco IEM-3000-8FM expansion modules. Depending on
the mix of switches and expansion modules, you can have up to 24 Fast Ethernet ports.
Note The expansion modules cannot operate as standalone devices.

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes