Cisco IE-3000-8TC Hardware Installation Guide

Contents
iv
Cisco IE 3000 Switch Hardware Installation Guide
OL-13017-01
Installation Guidelines 2-3
Environment and Enclosure Guidelines: 2-3
Other Guidelines 2-3
Verifying Package Contents 2-5
Adding Modules to the Switch 2-5
Expansion Module Configurations 2-5
Connecting Modules 2-8
Installing or Removing the Compact Flash Memory Card 2-10
Verifying Switch Operation 2-11
Connecting a PC or a Terminal to the Console Port 2-12
Connecting the Protective Ground and DC Power 2-13
Grounding the Switch 2-13
Wiring the DC Power Source 2-16
Attach the Power and Relay Connector to the Switch 2-21
Running POST 2-22
Power On the Switch 2-22
Verify POST Results 2-22
Disconnect Power 2-22
Installing the Switch 2-23
Installing the Switch on a DIN Rail 2-23
Installing the Switch on the Wall 2-27
Installing the Switch in a Rack 2-29
Removing the Switch from a DIN Rail or a Rack 2-31
Connecting Power and Alarm Circuits 2-32
Wiring the Protective Ground and DC Power 2-32
Wiring the External Alarms 2-33
Connecting Destination Ports 2-36
Connecting to 10/100 and 10/100/1000 Ports 2-36
Installing and Removing SFP Modules 2-37
Installing SFP Modules into SFP Module Slots 2-38
Removing SFP Modules from SFP Module Slots 2-40
Connecting to SFP Modules 2-41
Connecting to a Dual-Purpose Port 2-42
Connecting to 100BASE-FX Ports 2-43
Connecting the Switch to the Power Converter 2-44
Attaching the Power Converter to the Switch 2-45
Installing the Power Converter on a DIN Rail, Wall, or Rack Adapter 2-46
Connecting the DC Power Clip 2-46
Connecting the Power Converter to an AC Power Source 2-47

Cisco IE-3000-8TC Specifications

General

Switching Capacity	16 Gbps
MAC Address Table Size	8000
Uplink Ports	2 x 10/100/1000Base-T or SFP (Small Form-Factor Pluggable)
Operating Temperature	-40°C to 70°C
Mounting	DIN rail
Ports	8 x Ethernet 10/100Base-TX ports
Jumbo Frame Support	Yes