Cisco III - Supervisor Engine III User Manual

2-32
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
C7600_SIP200_SPITX Messages
Error Message %C7600_SIP200_SPITX-3-CHANNEL_ENABLE_FAIL: SPI4 Channel [int] for Bay
[int], [chars] Failed
Explanation
The specified SPI4 channel could not be enabled or disabled.
Recommended Action If this problem recurs, search for resolved software issues using the Bug
Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPITX-3-DESCR_ERR_SPA0: SPAstatus=[hex],
syndrome=[hex], RdRspOvf=[int], RdRspTo=[int], OvfVal=[int], OvfCh=[int],
OvfDescHi=[hex], OvfDescLo=[hex], DisChk=[int], SeqErrVal=[int], SeqErrCh=[int]
Explanation
The egress SPI4.2 device on the line card detected a sequence or FIFO overflow error
while processing a TX descriptor. This condition could cause packets to drop.
Recommended Action If this problem recurs, search for resolved software issues using the Bug
Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.
Error Message %C7600_SIP200_SPITX-3-DESCR_ERR_SPA1: SPAstatus=[hex],
syndrome=[hex], RdRspOvf=[int], RdRspTo=[int], OvfVal=[int], OvfCh=[int],
OvfDescHi=[hex], OvfDescLo=[hex], DisChk=[int], SeqErrVal=[int], SeqErrCh=[int]
Explanation
The egress SPI4.2 device on the line card detected a sequence or FIFO overflow error
while processing a TX descriptor. This condition could cause packets to drop.
Recommended Action If this problem recurs, search for resolved software issues using the Bug
Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require
assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support
representative and provide the representative with the output of the show tech-support command
for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command
for the SPA.

Cisco III - Supervisor Engine III Specifications

General

Brand	Cisco
Model	III - Supervisor Engine III
Category	Software
Language	English