Send document comments to nexus7k-docfeedback@cisco.com
9-34
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 9 Replacement Procedures
Replacing a Cisco Nexus 7010 or 7018 Fabric Module During Operations
Step 6 Holding each ejector lever, pull the module part way out of its slot.
Step 7 Grasp the front edge of the module and place your other hand under the module to support its weight.
Pull the module out of its slot. Do not touch the module circuitry.
Caution To prevent ESD damage, avoid touching the electronic circuitry and prevent anything else from coming
in contact with the circuitry.
Step 8 If you are removing the module from a Cisco Nexus 7010 chassis. turn the module counterclockwise so
that it is horizontal.
Step 9 Place the module on the antistatic mat or repack it in its original packing materials. If you are packing a
Cisco Nexus 7010 fabric module (N7K-C7010-FAB-1), see Figure 9-14. If you are packing a Cisco
Nexus 7018 fabric module (N7K-C7018-FAB-1), see Figure 9-15 on page 9-36.
To Next Page
Loading...
