Send document comments to nexus7k-docfeedback@cisco.com
9-45
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 9 Replacement Procedures
Replacing the Front Doors and Frame Assembly on the Cisco Nexus 7010 Chassis
d. Realign the EMI panel to the air intake area on the chassis and tighten its four captive screws to
8 in-lb (0.9 N·m).
Step 2 Remove the front doors by following these steps:
a. Unscrew the three screws that hold one door frame assembly to the chassis until the screws are no
longer in the chassis. Remove the door assembly from the chassis. See Figure 9-18.
b. Repeat step 4a for the other door assembly.
Figure 9-18 Removing the Front Door Assemblies
1 On each door frame, loosen three captive screws
and remove the door frame from the chassis.
To Next Page
Loading...
