Send document comments to nexus7k-docfeedback@cisco.com
9-59
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 9 Replacement Procedures
Replacing the Cable Management Frame on the Cisco Nexus 7018 Chassis
Figure 9-30 Cable Management Assemblies Attached to the Rack-Mount Brackets
Step 6
Place the top cover on top of the two upper cable management assemblies that are already installed.
Make sure that the side of the top cover that is closest to the chassis has two alignment pins that align
with the alignment holes in the chassis as shown in Figure 9-31. Push the top cover toward the chassis
so that its alignment pins enter the alignment holes and the top cover rests against the chassis.
1 Lower cable management assembly 2 Upper cable management assembly
To Next Page
Loading...
