Cisco Nexus 7000 Series - Page 326

Send document comments to nexus7k-docfeedback@cisco.com
B-2
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Appendix B Transceivers and Module Connectors
10-Gigabit SFP+ Transceivers and Fabric Extender Transceivers
Figure B-1 identifies the major features of these transceivers. For the cable specifications that apply to
these transceivers (FETs), see Table B-2. For the physical and environmental specifications, see
Table B-3. For the environmental specifications that apply to these transceivers, see Table B-4.
Figure B-1 SFP+ Transceivers and FETs
Table B-1 SFP+ Transceivers Used with Each I/O Module
Transceiver
I/O Module
8-port 10-Gigabit
(N7K-M108X2-12L)
32-port 10-Gigabit
(N7K-M132XP-12)
32-port 10-Gigabit
with XL option
(N7K-M132XP-12L)
32-port 1- and
10-Gigabit
(N7K-F132XP-15)
48-port 1- and
10-Gigabit
(N7K-F248XP-25)
SFP-10G-FET X
1
X
1
X
1
SFP-10G-ER X X X X
SFP-10G-LR X X X
2
X
SFP-10G-LRM X X X
SFP-10G-SR X
3
XX X X
SFP-H10GB-CU1M X
3
X
2
XX
SFP-H10GB-CU3M X
3
X
2
XX
SFP-H10GB-CU5M X
3
X
2
XX
SFP-H10GB-ACU7M X
2
XXX
SFP-H10GB-ACU10M X
2
XXX
1. The FET-10G transceiver is used only for connections with a Cisco Nexus 2248TP, 2232PP, and 2224TP Fabric Extender (FEX).
2. Requires revision 2 of this transceiver.
3. Requires the OneX Converter Module (part number CVR-X2-SFP10G) when this transceiver is used with the 8-port 10-GB I/O module.
1 Receive optical bore 4 Clasp shown in open position
2 Transmit optical bore 5 Dust plug
3 Clasp shown in closed position