Send document comments to nexus7k-docfeedback@cisco.com
B-5
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Appendix B Transceivers and Module Connectors
10-Gigabit X2 Transceivers
Additionally, you can use the following SFP+ transceivers with the OneX Converter Module (part
number CVR-X2-SFP10G) that adapts SFP+ transceivers to X2 ports:
• SFP-10G-SR
• SFP-H10GB-CUxM
For information on the SFP+ 10GB transceivers, see the “10-Gigabit SFP+ Transceivers and Fabric
Extender Transceivers” section on page B-1.
Figure B-2 identifies the major features of the X2 transceivers, and Figure B-3 shows the transceiver
with its latching sleeve extended (you pull the sleeve out to remove the transceiver from the I/O module).
Figure B-2 10-Gigabit X2 Transceiver (Latching Sleeve Not Extended)
1 Transmit optical bore 5 Transceiver heat sink
2 Receive optical bore 6 Module connector
3 Latching sleeve (retracted) 7 Latch (extended when sleeve is retracted)
4 EMI gasket
To Next Page
Loading...
