Cisco Nexus 9000 Series - Licensing Requirements for IP Acls

Region NameFeature Name
system
The region size cannot be
changed.
Note
System-managed ACLs
vpc-convergence
Setting this region size to 0
might affect the convergence
times of vPC link failures.
Note
vPC convergence
This region boosts the convergence times when a vPC
link goes down and traffic needs to be redirected to
the peer link.
Note
fex-ifacl, fex-ipv6-ifacl, fex-ipv6-qos,
fex-mac-ifacl, fex-mac-qos, fex-qos,
fex-qos-lite
Fabric extender (FEX)
arp-etherDynamic ARP inspection (DAI)
ipsgIP source guard (IPSG)
mcast_bidirMulticast PIM Bidir
mplsStatic MPLS
natNetwork address translation (NAT)
ing-netflowNetFlow
openflowOpenFlow
sflowsFlow
egr-sup: Egress supervisor (Cisco Nexus
9200 Series switches only)
ing-sup: Ingress supervisor (Cisco Nexus
9200 Series switches only)
Supervisor modules
Related Topics
Configuring ACL TCAM Region Sizes, on page 240
Configuring TCAM Carving, on page 250
Licensing Requirements for IP ACLs
The following table shows the licensing requirements for this feature:
License RequirementProduct
No license is required to use IP ACLs. Any feature not included in a license package is bundled
with the nx-os image and is provided at no extra charge to you. For an explanation of the
Cisco NX-OS licensing scheme, see the Cisco NX-OS Licensing Guide.
Cisco
NX-OS
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
228
Configuring IP ACLs
Licensing Requirements for IP ACLs