PurposeCommand
Displays the login parameters. The
failures option displays
information related only to failed
login attempts.
The clear login failures
command clears the
login failures in the
current watch period.
Note
show login [failures]
Displays whether the switch is
configured to log failed
authentication messages to the
syslog server.
show login on-failure log
Displays whether the switch is
configured to log successful
authentication messages to the
syslog server.
show login on-successful log
Displays the AAA configuration in
the running configuration.
show running-config aaa [all]
Displays the maximum number of
login sessions allowed per user.
show running-config all | i max-login
Displays the AAA configuration in
the startup configuration.
show startup-config aaa
Displays the minimum and
maximum length of the user
password.
show userpassphrase {length | max-length | min-length}
Configuration Examples for AAA
The following example shows how to configure AAA:
aaa authentication login default group radius
aaa authentication login console group radius
aaa accounting default group radius
Configuration Examples for Login Parameters
The following example shows how to configure the switch to enter a 100-second quiet period if 3 failed login
attempts is exceeded within 60 seconds. This example shows no login failures.
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
35
Configuring AAA
Configuration Examples for AAA
To Next Page
Loading...
