Cisco Nexus 9000 Series - Verifying the Rate Limit Configuration; Configuration Examples for Rate Limits

SUMMARY STEPS
1. clear hardware rate-limiter {all | access-list-log | bfd | exception | fex | layer-3 glean | layer-3 multicast
local-groups | span-egress [module module] }
DETAILED STEPS
PurposeCommand or Action
Clears the rate limit statistics.clear hardware rate-limiter {all | access-list-log | bfd |
exception | fex | layer-3 glean | layer-3 multicast
local-groups | span-egress [module module] }
Step 1
Example:
switch# clear hardware rate-limiter access-list-log
Verifying the Rate Limit Configuration
To display the rate limit configuration information, perform the following tasks:
PurposeCommand
Displays the rate limit
configuration.
show hardware rate-limiter [access-list-log | bfd | exception | fex |
layer-3 glean | layer-3 multicast local-groups | span-egress | module
module]
Configuration Examples for Rate Limits
The following example shows how to configure rate limits for packets copied to the supervisor module for
access list logging:
switch(config)# hardware rate-limiter access-list-log
switch(config)# show hardware rate-limiter access-list-log
Units for Config: packets per second
Allowed, Dropped & Total: aggregated since last clear counters
Module: 4
R-L Class Config Allowed Dropped Total
+------------------+--------+---------------+---------------+-----------------
+
access-list-log 100 0 0 0
Port group with configuration same as default configuration
Eth4/1-36
Module: 22
R-L Class Config Allowed Dropped Total
+------------------+--------+---------------+---------------+-----------------
+
access-list-log 100 0 0 0
Port group with configuration same as default configuration
Eth22/1-0
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
498
Configuring Rate Limits
Verifying the Rate Limit Configuration