DefaultParameters
DisabledDHCP snooping Option 82 support
UntrustedDHCP snooping trust
EnabledDHCP relay agent
EnabledDHCPv6 relay agent
DisabledVRF support for the DHCP relay agent
DisabledVRF support for the DHCPv6 relay agent
DisabledDHCP Option 82 for relay agent
DisabledDHCP smart relay agent
NoneDHCP server IP address
Configuring DHCP
Minimum DHCP Configuration
Step 1 Enable the DHCP feature.
When the DHCP feature is disabled, you cannot configure DHCP snooping.
Step 2 Enable DHCP snooping globally.
Step 3 Enable DHCP snooping on at least one VLAN.
By default, DHCP snooping is disabled on all VLANs.
Step 4 Make sure that the DHCP server is connected to the device using a trusted interface.
Step 5 (Optional) Enable the DHCP relay agent.
Step 6 (Optional) If DHCP servers and clients are in different VRFs, do the following:
a) Enable Option 82 for the DHCP relay agent.
b) Enable VRF support for the DHCP relay agent.
Step 7 (Optional) Configure an interface with the IP address of the DHCP server.
Enabling or Disabling the DHCP Feature
You can enable or disable the DHCP feature on the device. By default, DHCP is disabled.
When the DHCP feature is disabled, you cannot configure the DHCP relay agent, DHCP snooping, or any of
the features that depend on DHCP. In addition, all DHCP configuration is removed from the device.
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
337
Configuring DHCP
Configuring DHCP
To Next Page
Loading...
