Cisco Nexus 9000 Series - Page 268

PurposeCommand or Action
• fex-ipv6-ifacl—Configures the size of the FEX IPv6
port ACL TCAM region.
• fex-ipv6-qos—Configures the size of the FEX IPv6
port QoS TCAM region.
• fex-mac-ifacl—Configures the size of the FEX MAC
port ACL TCAM region.
• fex-mac-qos—Configures the size of the FEX MAC
port QoS TCAM region.
• fex-qos—Configures the size of the FEX IPv4 port
QoS TCAM region.
• fex-qos-lite—Configures the size of the FEX IPv4
port QoS lite TCAM region.
• fhs—Configures the size of the fhs TCAM region.
You can configure TCAM for the fhs region on the
Cisco Nexus 9300 and 9500 Series switches.
• flow—Configures the size of the ingress flow counters
TCAM region.
• ifacl—Configures the size of the IPv4 port ACL
TCAM region.
• ifacl-udf—Configures the size of the IPv4 port ACL
user-defined field (UDF) TCAM region (Cisco Nexus
3232C and 3264Q switches only).
• ing-ifacl—Configures the size of the ingress IPv4,
IPv6, or MAC port ACL TCAM region (Cisco Nexus
9200, 9300, and 9300-EX switches only).
You can attach user-defined fields (UDFs)
to the ing-ifacl TCAM region to configure
UDF-based IPv4 or IPv6 port ACLs.
UDF-based IPv6 port ACLs are supported
for Cisco Nexus 9300-EX switches only.
For more information and configuration
instructions, see Configuring UDF-Based
Port ACLs, on page 257.
Note
• ing-l2qos—Configures the size of the ingress Layer
2 QoS TCAM region (Cisco Nexus 9200 switches
only).
• ing-l2-span-filter—Configures the size of the ingress
Layer 2 SPAN filter TCAM region (Cisco Nexus 9200
and 9300-EX switches only).
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
242
Configuring IP ACLs
Configuring ACL TCAM Region Sizes