Cisco Nexus 9000 Series - Page 271

PurposeCommand or Action
• ns-qos—Configures the size of the IPv4 port QoS
TCAM region for the X9536PQ, X9564PX, and
X9564TX line cards and the M12PQ generic expansion
module (GEM).
• ns-vqos—Configures the size of the IPv4 VLAN QoS
TCAM region for the X9536PQ, X9564PX, and
X9564TX line cards and the M12PQ generic expansion
module (GEM).
• openflow—Configures the size of the OpenFlow
TCAM region.
• qos—Configures the size of the IPv4 port QoS TCAM
region.
• qos-lite—Configures the size of the IPv4 port QoS
lite TCAM region.
• racl—Configures the size of the IPv4 router ACL
(RACL) TCAM region.
• racl-lite—Configures the size of the IPv4 router ACL
(RACL) lite TCAM region (Cisco Nexus 3232C and
3264Q switches).
• racl-udf—Configures the size of the IPv4 router ACL
(RACL) user-defined field (UDF) TCAM region
(Cisco Nexus 3232C and 3264Q switches).
• redirect—Configures the size of the redirect TCAM
region.
• redirect-tunnel—Configures the size of the
redirect-tunnel TCAM region, which is used for BFD
over VXLAN.
This command is supported only if the
TP_SERVICES_PKG license is installed.
Note
• rp-ipv6-qos—Configures the size of the IPv6 port
QoS TCAM region for the 100G 9408PC line card and
the 100G M4PC generic expansion module (GEM).
• rp-mac-qos—Configures the size of the MAC port
QoS TCAM region for the 100G 9408PC line card and
the 100G M4PC generic expansion module (GEM).
• rp-qos—Configures the size of the IPv4 port QoS
TCAM region for the 100G 9408PC line card and the
100G M4PC generic expansion module (GEM).
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
245
Configuring IP ACLs
Configuring ACL TCAM Region Sizes