EasyManuals Logo

Cisco RV130W Administration Guide

Cisco RV130W
141 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
Configuring VPN
Configuring Site-to-Site IPsec VPN Advanced Parameters
Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide 104
6
- DES—8 characters
- 3DES—24 characters
- AES-128—16 characters
- AES-192—24 characters
- AES-256—32 characters
Manual Integrity Algorithm—Select the algorithm used to verify the
integrity of the data.
Key-In, Key Out—Enter the integrity key (for ESP with Integrity-mode) for
the inbound and outbound policy. The length of the key depends on the
algorithm chosen:
- MD516 characters
- SHA-1—20 characters
- SHA2-256—32 characters
STEP 5 For an Auto policy type, enter the settings in the Auto Policy Parameters section.
SA-Lifetime—Enter the duration of the Security Association in seconds.
After the specified number of seconds, the Security Association is
renegotiated. The default value is 3600 seconds. The minimum value is 300
seconds.
Encryption Algorithm—Select the algorithm used to encrypt the data.
Integrity Algorithm—Select the algorithm used to verify the integrity of the
data.
PFS Key GroupCheck the Enable box to enable Perfect Forward Secrecy
(PFS) to improve security. While slower, this protocol helps to prevent
eavesdroppers by ensuring that a Diffie-Hellman exchange is performed for
every phase-2 negotiation.
DH GroupSpecify the DH Group algorithm used when exchanging a pre-
shared key. The DH Group sets the strength of the algorithm in bits. Ensure
that the DH Group is configured identically on both sides of the IKE policy.
Select IKE Policy—Choose the IKE policy that will define the
characteristics of the SA negotiation.
STEP 6 Click Save.

Table of Contents

Other manuals for Cisco RV130W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco RV130W and is the answer not in the manual?

Cisco RV130W Specifications

General IconGeneral
DSL WAN-
Ethernet WANYes
SIM card slotNo
Wi-Fi bandSingle-band (2.4 GHz)
Wi-Fi standardsWi-Fi 5 (802.11ac), 802.11b, 802.11g, Wi-Fi 4 (802.11n)
Top Wi-Fi standardWi-Fi 5 (802.11ac)
WLAN data transfer rate (max)1000 Mbit/s
Cabling technology10/100/1000Base-T(X)
Networking standardsIEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.1D, IEEE 802.1p, IEEE 802.1w, IEEE 802.3, IEEE 802.3u
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet LAN interface typeGigabit Ethernet
USB 2.0 ports quantity1
Supported network protocolsDHCP, PPPoE, PPTP, L2TP, DNS, IGMP, RSTP
Antennas quantity2
Security algorithmsWEP, WPA, WPA2-PSK
Product typeTabletop router
Product colorBlack
LED indicatorsLAN, Power, USB, WAN, WLAN
Output voltage12 V
Power source typeDC
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 85 %

Related product manuals