Configuring Networking
Configuring LAN Settings
Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide 37
3
STEP 3 Click Save.
Configuring Link Aggregation
Use the Link Aggregation page to group multiple Ethernet links into a single logical
channel. Link aggregation groups improve the cost effectiveness of your device
by increasing cumulative bandwidth without requiring hardware upgrades, and
facilitates easy rerouting in case of a single port or cable failure.
Link The port speed. If no device is connected to the
port, this field displays Down.
Mode Choose from the drop-down menu one of the
following port speeds:
• Auto Negotiation—The device and the
connected device choose a common speed.
• 10Mbps Half—10 Mbps in both directions,
but only one direction at a time.
• 10Mbps Full—10 Mbps in both directions
simultaneously.
• 100Mbps Half—100 Mbps in both
directions, but only one direction at a time.
• 100Mbps Full—100 Mbps in both
directions simultaneously.
Jumbo Frame Check to enable jumbo frames on the device and
send frames within the LAN containing up to 9,000
bytes of data per frame. A standard Ethernet frame
contains 1,500 bytes of data.
Flow Control Check to enable flow control for this port.
Flow control is the process of managing the rate of
data transmission between two nodes to prevent a
fast sender from outrunning a slow receiver. It
provides a mechanism for the receiver to control
the transmission speed, so that the receiving node
is not overwhelmed with data from the transmitting
node.
To Next Page
Loading...
