EasyManuals Logo

Cisco RV130W Administration Guide

Cisco RV130W
141 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
3
Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide 16
Configuring Networking
Configuring Wired WAN Connections
Configuring WAN properties for an IPv4 network differs depending on which type
of Internet connection you have.
Configuring DHCP (Automatic Configuration)
If your Internet Service Provider (ISP) uses Dynamic Host Control Protocol (DHCP)
to assign you an IP address, you receive an IP address that is dynamically
generated each time you log in.
To configure DHCP WAN settings:
STEP 1 Choose Networking > WAN.
STEP 2 From the Internet Connection Type drop-down list, choose Automatic
Configuration - DHCP.
STEP 3 From the DNS Server Source drop-down list, choose one of the following ways to
set the DNS server address:
If you already have DNS server addresses from your ISP, choose Use these
DNS Servers, and enter the primary and secondary addresses.
If you do not have DNS server addresses from your ISP, choose Get
Dynamically from ISP.
To use the DNS servers provided by OpenDNS (208.67.222.222,
208.67.220.220) to resolve your web addresses, choose Use OpenDNS.
STEP 4 Click Save.

Table of Contents

Other manuals for Cisco RV130W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco RV130W and is the answer not in the manual?

Cisco RV130W Specifications

General IconGeneral
DSL WAN-
Ethernet WANYes
SIM card slotNo
Wi-Fi bandSingle-band (2.4 GHz)
Wi-Fi standardsWi-Fi 5 (802.11ac), 802.11b, 802.11g, Wi-Fi 4 (802.11n)
Top Wi-Fi standardWi-Fi 5 (802.11ac)
WLAN data transfer rate (max)1000 Mbit/s
Cabling technology10/100/1000Base-T(X)
Networking standardsIEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.1D, IEEE 802.1p, IEEE 802.1w, IEEE 802.3, IEEE 802.3u
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet LAN interface typeGigabit Ethernet
USB 2.0 ports quantity1
Supported network protocolsDHCP, PPPoE, PPTP, L2TP, DNS, IGMP, RSTP
Antennas quantity2
Security algorithmsWEP, WPA, WPA2-PSK
Product typeTabletop router
Product colorBlack
LED indicatorsLAN, Power, USB, WAN, WLAN
Output voltage12 V
Power source typeDC
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 85 %

Related product manuals