12-11
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
Chapter 12 Configuring Hybrid REAPWireless Device Access
Configuring Hybrid REAP
e. If you want to customize the content and appearance of the login page that guest users will see the
first time they access this WLAN, follow the instructions in Chapter 5.
f. To add a local user to this WLAN, click Security and then click Local Net Users under AAA.
g. When the Local Net Users page appears, click New. The Local Net Users > New page appears (see
Figure 12-6).
Figure 12-6 Local Net Users > New Page
h. In the User Name and Password fields, enter a username and password for the local user.
i. In the Confirm Password field, re-enter the password.
j. Check the Guest User check box to enable this local user account.
k. In the Lifetime field, enter the amount of time (in seconds) for this user account to remain active.
l. In the WLAN ID field, enter the number of the WLAN that will be accessed by the local user.
m. In the Description field, enter a descriptive title for the local user (such as “Guest user”).
n. Click Apply to commit your changes.
o. Click Save Configuration to save your changes.
Step 4 Go to the “Configuring an Access Point for Hybrid REAP” section on page 12-12 to configure two or
three access points for hybrid REAP.
To Next Page
Loading...
Need help?
General
