12-10
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
Chapter 12 Configuring Hybrid REAPWireless Device Access
Configuring Hybrid REAP
a. Follow the substeps in Step 1 to create a new WLAN. In our example, this WLAN is named
“guest-central.”
b. When the WLANs > Edit page appears, modify the configuration parameters for this WLAN using
the settings in Figure 12-5 as a reference. In our employee WLAN example, you would need to
choose None from both the Layer 2 Security and Layer 3 Security drop-down boxes, check the Web
Policy check box, and make sure Authentication is selected.
Note If you are using an external web server, you must configure a preauthentication access
control list (ACL) on the WLAN for the server and then choose this ACL as the WLAN
preauthentication ACL under Security Policies > Web Policy. See Chapter 5 for more
information on ACLs.
Note Make sure to enable this WLAN by checking the Admin Status check box under General
Policies.
Figure 12-5 WLANs > Edit Page (Centrally Switched Guest Access WLAN)
c. Click Apply to commit your changes.
d. Click Save Configuration to save your changes.
To Next Page
Loading...
Need help?
General
