Cisco SD2008T-NA User Manual

Contents
5
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
Enabling Wireless Connections to the Web-Browser and
CLI Interfaces
9
CHAPTER 3 Configuring Ports and Interfaces 1
Overview of Ports and Interfaces 2
Ports 2
Distribution System Ports 3
Service Port 5
Interfaces 5
Management Interface 6
AP-Manager Interface 6
Virtual Interface 7
Service-Port Interface 8
Dynamic Interface 8
WLANs 8
Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces 10
Using the GUI to Configure the Management, AP-Manager, Virtual, and Service-Port Interfaces 10
Using the CLI to Configure the Management, AP-Manager, Virtual, and Service-Port Interfaces 12
Using the CLI to Configure the Management Interface 12
Using the CLI to Configure the AP-Manager Interface 13
Using the CLI to Configure the Virtual Interface 14
Using the CLI to Configure the Service-Port Interface 15
Configuring Dynamic Interfaces 15
Using the GUI to Configure Dynamic Interfaces 15
Using the CLI to Configure Dynamic Interfaces 17
Configuring Ports 19
Configuring Port Mirroring 22
Configuring Spanning Tree Protocol 23
Using the GUI to Configure Spanning Tree Protocol 24
Using the CLI to Configure Spanning Tree Protocol 28
Enabling Link Aggregation 29
Link Aggregation Guidelines 33
Using the GUI to Enable Link Aggregation 34
Using the CLI to Enable Link Aggregation 35
Verifying LAG Settings Using the CLI 35
Configuring Neighbor Devices to Support LAG 35
Configuring a 4400 Series Controller to Support More Than 48 Access Points 36
Using Link Aggregation 36
Using Multiple AP-Manager Interfaces 36

Cisco SD2008T-NA Specifications

General

Brand	Cisco
Model	SD2008T-NA
Category	Extender
Language	English