Cisco SG500-28P Administration Guide

Cisco 500 Series Stackable Managed Switch Administration Guide 5
Contents
Setting LLDP Properties 125
Editing LLDP Port Settings 126
LLDP MED Network Policy 128
Configuring LLDP MED Port Settings 130
Displaying LLDP Port Status 131
Displaying LLDP Local Information 132
Displaying LLDP Neighbors Information 136
Accessing LLDP Statistics 140
LLDP Overloading 141
Configuring CDP 143
Setting CDP Properties 143
Editing CDP Interface Settings 146
Displaying CDP Local Information 147
Displaying CDP Neighbors Information 149
Viewing CDP Statistics 151
Chapter 10: Port Management 152
Configuring Ports 152
Setting Port Configuration 153
Configuring Link Aggregation 156
Link Aggregation Overview 157
Load Balancing 157
Default Settings and Configuration 158
Static and Dynamic LAG Workflow 158
Defining LAG Management 159
Configuring LAG Settings 160
Configuring LACP 162
LACP Priority and Rules 162
LACP With No Link Partner 162
Setting LACP Parameter Settings 163
Configuring Green Ethernet 164
Green Ethernet Overview 164
Power Saving by Disabling Port LEDs 165

Cisco SG500-28P Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Flash Memory	32 MB
Operating Humidity	10% to 90% non-condensing
PoE	Yes
Layer	Layer 2 and Layer 3
Stackable	Yes
Power Supply	Internal
Management	Web-based GUI, CLI, SNMP
Jumbo Frame Support	Yes
VLANs	4096 VLANs
MAC Address Table Size	16K entries
Dimensions	440 x 44 x 350 mm
Operating Temperature	0°C to 45°C
Ports	28 (24 x 10/100/1000 PoE+ ports, 4 x 10/100/1000/SFP combo ports)