Cisco SPA500 Series User Manual

Using Basic Phone Functions
Using Phone Hardware and Accessories
Cisco Small Business Pro IP Phone SPA50X User Guide (SIP) 27
3
Using Phone Hardware and Accessories
Using the Speakerphone
To use the speakerphone, press the Speaker button (the handset can be either on
or off hook).
Using the Headset with Your IP Phone
Install the headset as described in the “Connecting Wired and Wireless
Headsets (Optional)” section on page 21.
NOTE Steps to use your headset with the IP phone may vary. Consult the user
documentation for your headset for more information.
To use a wired headset, press the Headset button on your phone and dial the
number to place a call, or press the headset button to answer a ringing call.
To use a wireless headset, lift the receiver off hook before speaking or listening
through the headset.
Switching Between the Handset/Headset/Speakerphone
During a Call
Any of these audio devices can be used during a call. Only one device at a time
can be used.
The handset can be on the hook when using the speakerphone or headset
function. If switching from the handset to the speakerphone, make sure the
speakerphone or headset light is illuminated before placing the handset back on
the hook. (If you are switching from the handset to a wireless headset, however, do
not replace the handset or you will disconnect the call.)
Sending Audio to the Phone Speaker
Choosing this option sends audio to the speaker when the handset is lifted.

Cisco SPA500 Series Specifications

General

Brand	Cisco
Model	SPA500 Series
Category	IP Phone
Language	English