Cisco SPS208G User Manual

Spanning Tree
RSTP Port Settings
SPS208G/SPS224G4/SPS2024 Service Provider Switches User Guide 197
10
• Port State — Indicates the RSTP status on the specific port. The possible
field values are:
- Disabled — Indicates that STP is currently disabled on the port or if the
port is not active. The port forwards traffic while learning MAC
addresses.
- Blocking — Indicates that the port is currently blocked and cannot
forward traffic or learn MAC addresses.
- Listening — Indicates that the port is in Listening mode. The port cannot
forward traffic nor can it learn MAC addresses.
- Learning — Indicates that the port is in Learning mode. The port cannot
forward traffic, however it can learn new MAC addresses.
- Forwarding — Indicates that the port is in Forwarding mode. The port
can forward traffic and learn new MAC addresses.
• Point-to-Point Admin Status — Indicates whether a point-to-point link is
established on the port. Ports defined as Full Duplex are considered Point-
to-Point port links. The possible field values are:
- Enable — Device establishes point-to-point, full duplex links.
- Disable — Device establishes shared, half duplex links.
- Auto — Device automatically determines the state.
• Point-to-Point Oper Status — Indicates the Point-to-Point operating state.
• Activate Protocol Migration Test — Click the Activate button to run a
Protocol Migration Test. The test identifies the STP mode of the interface
connected to the selected interface.

Cisco SPS208G Specifications

General

Brand	Cisco
Model	SPS208G
Category	Switch
Language	English