Cisco WRVS4400N - Small Business Wireless-N Gigabit Security Router - Page 146

Setting Up and Configuring the WRVS4400N Wireless-N Router
Configuring the L2 Switch Settings
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide 146
5
Configuring RADIUS Mode
The L2 Switch > RADIUS window displays the settings for configuring and
enabling the RADIUS mode for the router.
The RADIUS mode provides authentication on devices connecting to the LAN
ports. This mode requires the installation of a RADIUS server on your local
network.
To configure the RADIUS mode for the server, follow these steps:
STEP1 Click L2 Switch > RADIUS.
STEP 2 Configure the RADIUS mode:
• Mode—Select Enabled or Disabled from the drop-down menu.
• RADIUS IP—Enter the RADIUS server’s IP address.
• RADIUS UDP Port—Enter the UDP port used to verify the RADIUS server
authentication.
• RADIUS Secret—Enter the key string used for authenticating and
encrypting all RADIUS communication between the router and the RADIUS
server. This key must match the RADIUS server’s configuration.