Cisco WRVS4400N - Small Business Wireless-N Gigabit Security Router - Page 34

Setting Up and Configuring the WRVS4400N Wireless-N Router
Navigating the Utility
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide 34
5
Administration
This window allows you to administer the router through the following windows:
• Management—Allows you to alter the router’s password, its access
privileges, SNMP settings, and UPnP settings.
• Log—Allows the configuration of Log settings.
• Diagnostics—Allows you to check the connection between the router and
another network device on the LAN or Internet.
• Backup & Restore—Allows you to back up and restores the Gateway's
configuration file.
• Factory Defaults—Allows you to restore the router’s factory defaults.
• Reboot—Allows you to reboot the router.
• Firmware Upgrade—Allows you to upgrade the router’s firmware.
IPS
This window allows you to carry out advanced configuration of the built-in
Intrusion Prevention System (IPS) inside the router through the following windows:
• Configure—Enables or disables IPS functions.
• P2P/IM—Allows or blocks specific Peer-to-Peer (P2P) networks and
Instant Messaging (IM) applications.
• Report—Provides reports of network traffic and malicious attacks.
• Information—Provides the signature file version and the protection scope
of the IPS system.