34-67
Catalyst 3750 Switch Software Configuration Guide
78-16180-02
Chapter 34 Configuring IP Unicast Routing
Configuring Protocol-Independent Features
To delete an entry, use the no route-map map tag global configuration command or the no match or no
set route-map configuration commands.
You can distribute routes from one routing domain into another and control route distribution.
Beginning in privileged EXEC mode, follow these steps to control route redistribution. Note that the
keywords are the same as defined in the previous procedure.
To disable redistribution, use the no form of the commands.
The metrics of one routing protocol do not necessarily translate into the metrics of another. For example,
the RIP metric is a hop count, and the IGRP metric is a combination of five qualities. In these situations,
an artificial metric is assigned to the redistributed route. Uncontrolled exchanging of routing information
between different routing protocols can create routing loops and seriously degrade network operation.
Step 23
show route-map Display all route maps configured or only the one
specified to verify configuration.
Step 24
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
router {bgp | rip | ospf | igrp | eigrp} Enter router configuration mode.
Step 3
redistribute protocol [process-id] {level-1 | level-1-2 |
level-2} [metric metric-value] [metric-type type-value]
[match internal | external type-value] [tag tag-value]
[route-map map-tag] [weight weight] [subnets]
Redistribute routes from one routing protocol to
another routing protocol. If no route-maps are
specified, all routes are redistributed. If the keyword
route-map is specified with no map-tag, no routes are
distributed.
Step 4
default-metric number Cause the current routing protocol to use the same
metric value for all redistributed routes (BGP, RIP and
OSPF).
Step 5
default-metric bandwidth delay reliability loading mtu Cause the IGRP or EIGRP routing protocol to use the
same metric value for all non-IGRP redistributed
routes.
Step 6
no default-information {in | out} Disable the redistribution of default information
between IGRP processes, which is enabled by default.
Step 7
end Return to privileged EXEC mode.
Step 8
show route-map Display all route maps configured or only the one
specified to verify configuration.
Step 9
copy running-config startup-config (Optional) Save your entries in the configuration file.
To Next Page
Loading...
Need help?
General