Citizen CT-E651 - ESC 3 N

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 108 -
ESC 3 n
[Function] Setting line feed rate of minimum pitch
[Code] <1B>H<33>H<n>
[Range] 0≤n≤255
[Outline] [The specification which is common to the model]
Sets the line feed width per line to [n×basic calculation pitch] inches.
[Caution] [The specification which is common to the model]
• The line feed width can be set separately for the STANDARD and PAGE MODES.
• The basic calculation pitch is set by GS P. Once defined, the line feed width is not changed if the basic
calculation pitch is changed by GS P.
• Fractions resulting from calculation are corrected with the minimum pitch of the mechanism, and the
remainder is omitted.
• In STANDARD MODE, this command uses the vertical (paper feed direction) basic calculation pitch (y).
• In PAGE MODE, this command acts differently depending on the start point:
(1) If the start point specified by ESC T is top left or bottom right, the command uses the vertical (paper feed
direction) basic calculation pitch (y).
(2) If the start point specified by ESC T is top right or bottom left, the command uses the horizontal
(perpendicular to the paper feed direction) basic calculation pitch (x).
• The maximum settable line feed width is 1016 mm (40 inches). A setting greater than this maximum is
trimmed to the maximum.
[Default] [The specification which depend on the model]
CT-S280/CT-S281/CT-S300/CT-S310/CT-P29x series
Approx. 4.23mm
CT-S2000/CT-S4000/ CT-S801(II)/CT-S851(II)/CT-S601(II)/
CT-S65
1(II)/CT-S251/CT-D151/CT-E651
(1) MSW 5-2 OFF:
Approx. 4.23mm
(2) MSW 5-2 ON:
Approx. 3.75 mm
[See Also] ESC 2, GS P