Support
model
- 150 -
GS ^ n1 n2 n3
[Function] Executing the macro
[Code] <1D>H<5E>H<n1><n2><n3>
[Range] 0≤n1≤255
0≤n2≤255
0≤n3≤1
[Outline] [The specification which is common to the model]
• Executing contents defined in macro.
• n1 : The number of times of macro execution
• n2 : Waiting time on macro execution: Waiting time of n2 x 100 msec is given for every execution.
• n3 : Macro execution mode
n3 = 0 Continuous execution: The Macro is executed “n1” times continuously at the time interval
specified by “n2”.
n3 = 1 Execution by FEED Switch: After waiting for the time specified by “n2”, the ARARM LED
flickers and the FEED switch is waiting to be pressed. When it is
pressed, the macro is executed once. This action is repeated “n1”
times.
[Caution] [The specification which is common to the model]
• When this command is received while in macro definition, suspension of macro definition is
indicated. At this time, the defined content is cleared.
• No execution takes place when the macro is held undefined.
• While in macro execution with n3 = 1, paper feed with the FEED switch is not available.
• When MSW2-3 ON Spool print valid is specified, n2 is invalid.
[See Also] GS :
[Sample Program]
Refer to Sample Program and Print Results for GS:.
To Next Page
Loading...
