Support
model
- 182 -
2.2.14 Kanji Control Commands
FS ! n
[Function] Collectively setting Kanji print mode
[Code] <1C>H<21>H<n>
[Range] 0≤n≤255
[Outline] [The specification which is common to the model]
• Collectively sets Kanji print mode.
• Each bit of “n” has the following meaning:
Bit Function
Double-height enlargement
[Caution] [The specification which is common to the model]
• Setting both double-height and double-width enlargement causes four times enlargement.
• Underline is applied to all width of printed characters but not to the part skipped by HT. Underline is not applied
to the character rotated by 90° clockwise.
• Thickness of underline is the value set by FS – (defaulted to 1 dot width).
[Default] n=0
[See Also] FS -, FS W, GS !
To Next Page
Loading...
