Support
model
- 112 -
GS / m
[Function] Printing the downloaded bit image
[Code] <1D>H<2F>H<m>
[Range] 0≤m≤3, 48≤m≤51
[Caution] [The specification which is common to the model]
• Prints downloaded bit image in a mode specified by “m”.
• Modes that can be selected by “m” are shown below.
m Mode Name
Dot Density in
Vertical Direction
Dot Density in
Horizontal Direction
[Caution] [The specification which is common to the model]
• When a downloaded bit image has not been defined, this command is ignored.
• When data exist in the print buffer, this command is ignored.
• A portion of a downloaded bit image exceeding one line length is not printed.
[See Also] ESC &, GS *