Citizen CT-E651 - GS C 0 M N

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 198 -
GS C 0 m n
[Function] Setting the numbering print mode
[Code] <1D>H<43>H<30>H<m><n>
[Range] 0≤m≤5
0≤n≤2
[Outline] [The specification which is common to the model]
• This command sets the numbering (serial number counter) print mode.
• “m” denotes the number of print columns.
m=0 Prints the columns indicated by numeral. In this case, “n” has no meaning.
m=1 to 5 Indicates the maximum number of columns to be printed.
Prints the counter in “m” columns.
“n” specifies a printing position within the printing columns.
n=0 Prints the data right justified. The blank columns are spaced.
n=1 Prints the data right justified. The blank columns are filled with "0".
n=2 Prints the data left justified. The right blank will become invalid.
[Caution] [The specification which is common to the model]
• If either “m” or “n” has a value beyond their ranges, that setting will becomes invalid.
[Default] m=0, n=0
[See Also] GS C 1, GS C 2, GS C；, GS c
[Sample Program]
LPRINT CHR$(&H1D);"C0"; *CNT
LPRINT CHR$(0); CHR$(0); FOR I=1 TO 5
GOSUB *CNT LPRINT CHR$(&H1D);"c";
LPRINT CHR$(&H1D);"C0"; NEXT I
LPRINT CHR$(1); CHR$(0); LPRINT CHR$(&HA);
GOSUB *CNT RETURN
LPRINT CHR$(&H1D);"C0";
LPRINT CHR$(3);CHR$(0); [Print Results]
GOSUB *CNT
LPRINT CHR$(&H1D);"C0";
LPRINT CHR$(3); CHR$(1);
GOSUB *CNT
LPRINT CHR$(&H1D);"C0";
LPRINT CHR$(3); CHR$(2);
GOSUB *CNT
END
12345
67890
11 12 13 14 15
016017018019020
21 22 23 24 25
Counts from 1 to 5 at m = 0 and n = 0.
Counts from 6 to 10 at m = 1 and n = 0.
Counts from11 to 15 at m = 3 and n = 0.
Counts from 16 to 20 at m = 3 and n = 1.
Counts from 21 to 25 at m = 3 and n = 2.