Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
- 121 -
CT-S310II
(1) Printer status (When n = 1 is specified)
2
Status of pin 3 of drawer kick-out connector = L
Status of pin 3 of drawer kick-out connector = H
3
5
Not waiting online recovery
6
FEED switch is not pressed
(2) Status caused by an offline condition (When n = 2 is specified)
2
3
Not in paper feed state triggered by FEED
switch
00H 0
In paper feed state triggered by FEED switch
6
Bit 5: Printing is stopped if the Paper-end detector detects a “paper out”
state, or if the printer is out of paper when the Paper Near-end Sensor
is enabled by ESC c 4. At this time, bit 5 = 1.
(3) Status caused by an error (when n = 3 is specified)
2
No Mechanism error occurred.
A Mechanism error occurred.
3
Auto cutter error not occurred
Auto cutter error occurred
5
Unrecoverable error not occurred
Unrecoverable error occurred
6
Auto recovery error not occurred
Auto recovery error occurred
Bit 2: In case of MSW3-8=ON, it is generated by cover-open.
Bit 3: If this error occurred because of a paper jam, for example, remove
the cause of the error, and then DLE ENQ n (1≤n≤2) can be used to
recover from the error. However, it is not possible to recover from any
error due to a circuit problem (e.g., broken wire).
Bit 6: If a head overheat error is detected, the printing is stopped until the
head temperature falls. At this time, bit 6 = 1.
(4) Continuous paper detector status (When n = 4 is specified)
5
Paper found by Paper-end Sensor
Paper not found by Paper-end Sensor
6
Paper found by Paper-end Sensor
Paper not found by Paper-end Sensor
To Next Page
Loading...
